Configuring with Web Based Management
4.6 System
SINEMA Remote Connect - Server
Operating Instructions, 11/2017, C79000-G8976-C383-04
53
Setting the time manually
You set the date and time of the system in the "Manual" tab:
System time Shows the current system time in the format "DD.MM.YYYY HH:MM:SS". The
display depends on the language that is set.
Click the button to use the time setting of the PC.
Automatic time-of-day setting with NTP
If the time-of-day synchronization is via NTP, you can make the relevant settings in the
"NTP" tab:
When enabled, the automatic time synchronization via NTP is used.
System time Shows the current system time in the format "DD.MM.YYYY
HH:MM:SS". The display depends on the language that is set.
Time zone Enter the time zone you are using in the format "+/- HH:MM". The
time zone relates to UTC standard world time.
Last Synchronization Time Shows how the last time synchronization was performed. The follow-
ing methods are possible:
• not synchronized
• synchronized
Enter the IP address or host name of the primary NTP server.
Secondary NTP server Enter the IP address or host name of the primary secondary NTP
SMS messages and e-mails
4.6.4.1
To wake a station, the SINEMA RC Server sends an e-mail. The e-mail is sent to an SMS
gateway. The SMS gateway converts the e-mail into an SMS message and transfers this to
the device, e.g. an M87x . When the SMS message is accepted, the device establishes the
connection to the SINEMA RC Server.
The requirement is that the SIM card in the device is prepared to receive the SMS message.
You will find further information on this in the configuration manual of the device.
Note
The time at which the wake
-up SMS message will be sent to the station cannot be predicted
precisely and depends on the current network load. Due to special events, an SMS message
can take a long time to arrive. Take this into account when you send the wake
-up SMS
Monitoring and time response of wake-up SMS messages (Page 116).
To Next Page
Loading...
