Siemens SINEMA Remote Connect - Debug Login

Configuring with Web Based Management
4.6 System
SINEMA Remote Connect - Server
64 Operating Instructions, 11/2017, C79000-G8976-C383-04
4.6.9
Debug login
The Debug login allows your Siemens contact access to the SINEMA RC Server for a certain
time. In SINEMA RC Server, there are predefined user names intended for service and
debugging purposes via SSH.
On this page, you specify the password for the Debug login.
Calling the Web page
In the navigation, select "System > Debug-Login".
Activating Debug login
1. Make the following settings:
Box
Meaning
Debug login timeout
(minutes)
Specify the duration of the access.
When this time elapses user is automatically logged off.
Debug login port Specify the TCP port via which the system of the SINEMA RC
Server is accessed.
You may need to set up PORT forwarding to SINEMA RC on the
Internet
router.
Debug login password Enter the password.
The new password must be at least 8 characters long and contain
special characters, upper and lowercase characters as well as
numbers, refer to the section "Permitted characters (Page 21)".
Confirm debug login pass-
word
Confirm this password.
2. Activate "Enable debug login" and click on "Save".
When the settings are saved, the remaining time is displayed in the "Remaining time
(minutes)" box.
Deactivating Debug-Login
1. Deactivate "Enable debug login" and click on "Save".
The settings are returned to the default values and the password is deleted.