Siemens SINUMERIK 802S - Page 56

Start-Up
4.2 Turning on and booting the control system
4-56
SINUMERIK 802S
6FC5 597–2AA00–0BP2 (01.02)
Table 4-3 Boot errors
Error Message
Remedial Action
ERROR
EXCEPTION
1. Check the connections of the plugged or connected modules
(PLC D/IO modules).
ERROR
DRAM
2. Switch off the control system and back on again (POWER ON).
3. Carry out a software update.
ERROR
BOOT
4. Replace the hardware components.
5. Inform the hotline if necessary.
ERROR
NO BOOT2
ERROR
NO SYSTEM
ERROR
LOAD NC
NO SYSTEM-LOADER
ERROR
LOAD NC
CHECKSUM-ERROR
ERROR
LOAD NC
DECOMPRESS-ERROR
ERROR
LOAD NC
INTERNAL-ERROR 1