EasyManuals Logo

Siemens SINUMERIK 804D sl Programming Manual

Siemens SINUMERIK 804D sl
1334 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #639 background imageLoading...
Page #639 background image
3.8.3 Coarse and fine offsets (CTRANS, CFINE)
Fine offset
A fine offset CFINE(...) can be applied to the following frames:
Settable frames: $P_UIFR or $P_IFRAME
Basic frames: $P_NCBFR[<n>], $P_CHBFR[<n>], $P_CHBFRAMES[<n>] or
$P_ACTBFRAME
Programmable frame: $P_PFRAME
The fine offset of a frame is programmed with the CFINE(...) command.
Coarse offset
A coarse offset CTRANS(...) can be applied to all frames.
Total offset
The total offset results from the addition of the coarse and the fine offset.
Machine data
Enable of the fine offset
The fine offset is enabled with the machine data:
MD18600 $MN_MM_FRAME_FINE_TRANS = 1
Syntax
Fine offset
Complete frame
<frame> = CFINE(<K_1>,<value>)
<frame> = CFINE(<K_1>,<value>, <K_2>, <value>)
<frame> = CFINE(<K_1>,<value>, <K_2>, <value>, <K_3>, <value>)
Frame component
<frame>[<n>, <K_1>, FI] = <value>
Coarse offset
Complete frame
<frame> = CTRANS(<K_1>,<value>)
<frame> = CTRANS(<K_1>,<value>, <K_2,<value>)
<frame> = CTRANS(<K_1>,<value>, <K_2,<value>, <K_3,<value>)
Frame component
<frame>[<n>,<K_1>,TR] = <value>
Work preparation
3.8 Coordinate transformations (frames)
NC programming
Programming Manual, 12/2019, 6FC5398-2EP40-0BA0 639

Table of Contents

Other manuals for Siemens SINUMERIK 804D sl

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SINUMERIK 804D sl and is the answer not in the manual?

Siemens SINUMERIK 804D sl Specifications

General IconGeneral
BrandSiemens
ModelSINUMERIK 804D sl
CategoryControl Systems
LanguageEnglish

Related product manuals