Note
All workpiece counters are set to "0" when the control powers up with default values and can
be read and written independent of their activation.
Note
Channel-specific machine data can be used to control counter activation, counter reset timing
and the counting algorithm.
Note
Workpiece counting with user-defined M command
Machine data can be set so that the count pulses for the various workpiece counters are
triggered using user-defined M commands rather than the end of the program (M2/M30).
Work preparation
3.22 Program runtime/part counter
NC programming
Programming Manual, 12/2019, 6FC5398-2EP40-0BA0 987
To Next Page
Loading...
Need help?
General
