Tables
15.1 List of statements
Job planning
15-8 Programming Manual, 03/2006 Edition, 6FC5398-2BP10-1BA0
CTABINV
Define leading axis position
according to following axis
position from curve table
Real See CTAB
CTABISLOCK Returns the lock state of the curve table with
number n
Parameter n
CTABLOCK Set lock against deletion and overwriting Parameters n,
m, and
memType
CTABMEMTYP Returns the memory in which the curve table
has been created with number n
Parameter n
CTABMPOL Max. number of polynomials still possible in
the memory
memType
CTABMSEG Max. number of curve segments still possible
in the mem.
memType
CTABNO Number of defined curve tables irrespective of
mem. type
No parameters
CTABNOMEM Number of defined curve tables in SRAM or
DRAM memory.
memType
CTABPERIOD Returns the table periodicity with number n Parameter n
CTABPOL Number of polynomials already used in the
memory
memType
CTABPOLID Number of the curve polynomials used by the
curve table with number n
Parameter n
CTABSEG Number of curve segments already used in the
memory
memType
CTABSEGID Number of the curve segments used by the
curve table with number n
Parameter n
CTABSEV Returns the final value of the following axis of
a segment of the curve table
Segment is
determined by
LW
R10 =
CTABSEV(LW, n,
degree, Faxis,
Laxis)
CTABSSV Returns the initial value of the following axis of
a segment of the curve table
Segment is
determined by
LW
R10 =
CTABSSV(LW, n,
degree, Faxis,
Laxis)
CTABTEP Returns the value of the leading axis at curve
table end
Master value at
end of curve
table
R10 = CTABTEP(n,
degree, Laxis)
CTABTEV Returns the value of the following axis at curve
table end
Following value
at end of curve
table
R10 = CTABTEV(n,
degree, Faxis)
CTABTMAX Returns the maximum value of the following
axis of the curve table
Following value
of the curve
table
R10 =
CTABTMAX(n,
Faxis)
CTABTMIN Returns the minimum value of the following
axis of the curve table
Following value
of the curve
table
R10 =
CTABTMIN(n,
Faxis)
CTABTSP Returns the value of the leading axis at curve
table start
Master value at
beginning of
curve table
R10 = CTABTSP(n,
degree, Laxis)
To Next Page
Loading...
Need help?
General
