Tables
15.1 List of statements
Job planning
Programming Manual, 03/2006 Edition, 6FC5398-2BP10-1BA0
15-15
G Functions
G G function (preparatory
function)
The G functions are divided
into G groups. Only one G
function from one group can
be written in one block.
A G function can either be
modal (until canceled by
another function from the
same group), or non-modal
(only effective for the block it
is written in).
Only
integer,
predefined
values
G...
G0 Linear interpolation with rapid traverse
(rapid traverse motion)
G0 X... Z... m 1
G1
1
Linear interpolation with feedrate (linear
interpolation)
G1 X... Z... F... m 1
G2 Circular interpolation clockwise
Motion
commands
G2 X... Z... I... K... F...
;center and end point
G2 X... Z... CR=... F...
;radius and end point
G2 AR=... I... K... F...
;aperture angle and
;center point
G2 AR=... X... Z... F...
;aperture angle and
;end point
m 1
G3 Circular interpolation counter-clockwise G3 ... ; otherwise as for
G2
m 1
G4 Dwell time preset Special motion G4 F...
;dwell time in s or
G4 S...
;dwell time in
;spindle revolution.
;separate block
s 2
G9 Exact stop - deceleration s 11
G17
1
Selection of working plane X/Y Infeed direction Z m 6
G18 Selection of working plane Z/X Infeed direction Y m 6
G19 Selection of working plane Y/Z Infeed direction X m 6
G25 Lower working area limitation Value
assignments in
G25 X.. Y.. Z..;separate
block
s 3
G26 Upper working area limitation Channel axes G26 X.. Y.. Z..;separate
block
s 3
To Next Page
Loading...
Need help?
General
