09.91 4 Monitoring Functions
4.6 Listing of the alarms/alarm description
Alarm No.
Alarm Text:
2056
”Travel through transf. center”
Explanation:
Remedy:
– On the programmed contour, the radius axis (linear axis) wants to
traverse into the zero of the fictitious coordinate system.
– Change cutter radius.
– Program a different contour.
Alarm No.
Alarm Text:
2057
”Thread/rev. feedrate”
Reason:
Remedy:
Explanation:
– A thread has been programmed with G33, G34, G35, although this
function has not been implemented in the control.
– G95 thread rev. feedrate has been programmed
Correct program
Alarm only for SINUMERIK 810M
Alarm No.
Alarm Text:
2058
”3D option not avail.”
Reason:
Remedy:
Explanation:
In the program, 3 axes were programmed simultaneously
Correct program
Alarm only for SINUMERIK 810 M
Alarm No.
Alarm Text:
2059
”G92 program error”
Reason:
Remedy:
– Use of an invalid address character
– Error on cylindrical interpolation
G92 is only allowed with address ”S” (programmed spindle speed
limitation) or “P” (cylindrical interpolation)
Alarm No.
Alarm Text:
2060
”TO, ZO program error”
Reason: – A non-existent tool offset number was selected
– The value in the selected zero offset or tool offset is too large
Alarm No.
Alarm Text:
2061
”General programming error”
Effect:
Reason:
Inhibiting of NC START
– Contour calculation not possible
– Machine data for ”axis duplication” function incorrect.
© Siemens AG 1990 All Rights Reserved 6ZB5 410-0EQ02 4-17
SINUMERIK 810M, GA3 (BN)
To Next Page
Loading...
Need help?
General
