Siemens SINUMERIK 810M User Manual

4 Monitoring Functions 01.93
4.6 Listing of the alarms/alarm description
Alarm No.
Alarm Text:
2062
”Feed missing/not prog.”
Reason:
Remedy:
– No F value programmed
– F value too small (machine data)
– Feed per rev., G95 greater than 50mm/min per revolution
– No feed per rev. programmed
– The axial distance to go for the rotary axis with G98 or G36 is 0 or
no G98 feed has been programmed.
Program correct feed
Alarm No.
Alarm Text:
2063
”Thread lead too high”
Reason:
Effect:
Remedy:
A thread pitch of more than 400mm/rev.
(16 inch/rev.) has been programmed.
Inhibiting of Cycle Start
Program a smaller thread pitch
Alarm No.
Alarm Text:
2064
”Program error round (rotary) axis”
Reason:
Effect:
Remedy:
Explanation:
If you round to either a half or full degree on a rotary axis, the control
will monitor whether the programmed positions correlate with the
rounding.
– Inhibiting of NC START
– The programmed move in the block is not executed.
Program the correct rotary axis position
In the JOG, INC modes, the control automatically rounds to valid
values. In the AUTOMATIC or MDI AUTOMATIC modes, the control
only monitors the programmed positions, without rounding itself.
Alarm No.
Alarm Text:
2065
”Position behind SW overtravel”
Reason:
Effect:
Remedy:
The programmed block end-point lies behind the software limit switch.
– Inhibiting of NC START
– The programmed move is not executed
Correct program
Alarm-No.
Alarm Text:
2066
”Thread lead increase / decrease”
Reason:
Effect:
Remedy:
A thread lead increase or decrease of more than 16 mm / rev (0.6
inch/rev) has been programmed.
Inhibiting of NC START
Program a smaller thread lead increase / decrease
4-18
© Siemens AG 1990 All Rights Reserved 6ZB5 410-0EQ02
SINUMERIK 810M, GA3 (BN)

Siemens SINUMERIK 810M Specifications

General

Brand	Siemens
Model	SINUMERIK 810M
Category	Control Systems
Language	English