Connecting
6.2 Electrical connections
54
Quick Start
Compact Operating Instructions, 05/2018, A5E31805656-06
Detail view of option module connections
OM1.1 and OM2.1/2.2 with embossed connector numbers on the enclosure's rear panel
Processing module, Ethernet (MODBUS TCP), and 37-pin sub-D (female), digital inputs and
Optional module 1.1 25-pin sub-D (female), digital inputs and outputs
Optional module 2.1, 15-pin sub-D (male), digital outputs and analog outputs or
Optional module 2.2, 15-pin sub-D (female), digital inputs, analog inputs and analog outputs
Figure 6-9 Backplane of a rack-mounted device, connecting signal/Ethernet cables
1. Plug the signal cables into the associated sockets on the device rear in accordance with
the connection assignment.
2. Screw the signal cables tight to prevent them from falling out.
3. Plug the Ethernet cable into the socket
③.
You can find additional information on the setting of optional modules or MODBUS TCP
using the list of references in the following documentation:
● Operating manual LUI (Page 135)
● Operating manual PDM (Page 135)
To Next Page
Loading...
