Preface
7SJ61...7SJ63, 7SJ65, 6MD63 PROFIBUS-DP – Bus mapping
C53000-L1840-B006-02
ii
The PROFIBUS-DP specification and the structure of the PROFIBUS-
DP messages are defined in the European standard EN 50170:
Ø PROFIBUS Specification
Normative Parts of PROFIBUS-FMS, -DP., -PA
According to the European Standard
EN 50170 Volume 2
Edition 1.0, May 1998
PROFIBUS Nutzerorganisation e.V.
Order-No. 0.032 or 0.042 on CD ROM
Notes to this
manual
This manual provides you with the following aids to make it easier to
locate the information you are looking for:
• At the beginning of this manual you will find a complete table of
contents plus separate lists of figures and tables contained in this
manual.
• In the individual chapters, you will find information in the left margin
of each page which will give you an overview of the contents of that
particular paragraph.
• Following the last chapter of this manual, you will find a glossary
containing definitions of technical terms and abbreviations used in
this manual.
• At the end of this manual, you will find a comprehensive index for
fast access to the information you need.
Validity
This manual is valid for
• SIPROTEC devices 7SJ61...7SJ63, 7SJ65, 6MD63 with:
• firmware version 4.2 or higher (7SJ65: version 4.3 or higher)
and
• PROFIBUS-DP communication module version 01.01.02 or
higher.
For device parameterization DIGSI version 4.2 or higher has to be
used.
Training courses
See our catalog of courses for a list of available courses or contact our
Training center in Nuremberg.
Questions
If you have questions to the SIPROTEC devices, contact your Siemens
representative.
To Next Page
Loading...
Need help?
General
