Preface
ii
SIPROTEC Modbus - Bus mapping
C53000-L1840-C009-03
Validity This manual is valid for the SIPROTEC devices:
• 7UM62 (firmware version 4.0 or higher),
with
• Modbus communication module version 02.00.05 or higher,
• Modbus communication module version 03.00.04 or higher at use of the
Event recorder and Standard mapping 3-2.
For device parameterization have to be used:
• DIGSI 4.3 or higher,
• DIGSI 4.21 considering the preconditions explained in the manual “SIPROTEC
Communication module, Modbus - Communication profile” (ref. to page i),
• Modbus standard mappings 3-1 to 3-n (n = device type dependent number of
standard mappings).
Additional Support For questions regarding SIPROTEC4 devices, please contact your Siemens repre-
sentative.
Training courses Individual course offerings may be found in our Training Catalog and questions can be
directed to our Training Centre. Please contact your Siemens representative.
Target audience Protection engineers, commissioning engineers, personnel concerned with adjust-
ment, checking and service of selective protective equipment, automatic and control
facilities and personnel of electrical facilities and power plants.
To Next Page
Loading...
Need help?
General
