② Screw the motor starter protector on the DIN rail adapter. The motor starter protector sits tight on
the adapter.
Tightening torque: 1.5 ... 1.6 Nm
③ Insert the connectors on the link module (U
i
= 690 V), as shown in the gure, into the bottom main
conductor terminals on the motor starter protector.
④ Screw the main conductor terminals tight.
⑤ Slide the contactor onto the link module from below. Insert the connectors on the link module into
the top main conductor terminals on the contactor.
⑥ Screw the contactor to the DIN rail adapter. The contactor sits tight on the adapter.
Tightening torque: 1.5 ... 1.6 Nm
⑦ Screw the main conductor terminals of the contactor tight.
Mounting
7.3 Assembly and disassembly with dierent mounting systems
SIRIUS 3RA Load Feeders
82 Equipment Manual, 02/2022, A5E03656507520A/RS-AC/004
To Next Page
Loading...
