Siemens SITRANS F FST030 - Wizard - Zero Point Adjustment; Changing Parameter Settings Using SIMATIC PDM

SIMATIC PDM
B.1 Commissioning with SIMATIC PDM
SITRANS F Ultrasonic flowmeters FST030 (HART)
132 Operating Instructions, 08/2017, A5E35971532-AC
B.1.10
Wizard - Zero point adjustment
Open the menu Device → Wizard → Inline Configuration, and follow the steps.
Although the device zero is very stable from the factory the user has the ability to remove
any residual zero offset that may exist by performing the Zero Point Adjustment wizard.
B.1.11
Changing parameter settings using SIMATIC PDM
Note
For a complete list of parameters, see the Function Manual.
Clicking on Cancel during an upload from device to SIMATIC PDM will result in some
parameters NOT being updated.