Siemens SITRANS F FST030 - Process Values Wizard

Commissioning
6.6 Commissioning via local display
SITRANS F Ultrasonic flowmeters FST030 (HART)
60 Operating Instructions, 08/2017, A5E35971532-AC
Text
Options/Description
Path settings
Select "YES" to configure the path(s).
Installed paths
Select the paths installed.
Save settings
Moves to the next menu item.
Start measurement
* for each installed path. Select the path to configure.
Path geometry
Define the geometry of the path (direct or reflect mode)
Mounting path 1
Represents the spacing offset. Use Nom for most applications.
Path 1 Select "Receiver signal" to view graphical display of the receiver signal.
** Select "Next" to configure next path or to select "Next" to finish the
wizard.
6.6.1.4
Process values wizard
The Process values wizard will guide you through setup of process values for your
application. The prioritizing of the process values automatically configures the measurement
views on the display. The process value configured as first process value is set as first
display view.