SITRANS F Ultrasonic flowmeters FST030 (HART)
Operating Instructions, 08/2017, A5E35971532-AC
35
This chapter describes how to wire up the transmitter for operation with a sensor.
● Preparing for the connections (Page 41)
● Terminal layout (Page 42)
● Connecting channel 1 (Page 43)
● Connecting channels 2 to 4 (Page 44)
● Connecting the power supply (Page 48)
● Finishing the transmitter connection (Page 49)
For connection of the sensor, see the relevant sensor Installation Manual.
Connecting channels 5 and 6 (Page 47)
Missing PE/ground connection
Missing PE/ground connection
Risk of electric shock. May cause death or serious injury.
Depending on the device version, connect the power supply as follows:
•
: Ensure that the used socket has a PE/ground conductor connection. Check
that the PE/ground conductor connection of the socket and power plug match each
other.
•
: Connect the terminals according to the terminal connection
diagram. First connect the PE/ground conductor.
To Next Page
Loading...
