Siemens SITRANS F FST030 - 7 Operating; Operating Via the Local Display; Display Views; Access Control

SITRANS F Ultrasonic flowmeters FST030 (HART)
Operating Instructions, 08/2017, A5E35971532-AC
69
Operating
7
These Operating Instructions describe the operation via the local display (HMI). The device
can also be operated via various software.
7.1
Operating via the local display
7.1.1
Display views
There are six display views, all fully configurable. Use the and the keys to switch
between the operator views.
Four different types of views are available:
● Display of measured process values, see Reading the process values (Page 72).
● Display for totalizer operation, see Operating the totalizers (Page 74).
● Display of a list of active alarms, see Handling alarms (Page 75).
● Display of six configurable measurement/diagnostic values, see Reading the diagnostic
values (Page 76).
7.1.2
Access control
You can view all items in the HMI menu but the parameters are protected against changes
through access level control. To gain access, select one of the following access levels: