Siemens SITRANS F M MAG 5000 - 9 Service and maintenance; 9.1 Transmitter check list

Service and maintenance
9.2 Technical support
SITRANS F M MAG 5000/6000
58 Operating Instructions, 12/2013, A5E02338368-002
Power on transmitter
1.2.1
Transmitter OK
Check application
Check installation/sensor/earthing
connection etc.
1.2.2
Check cables/conndections
Check connection board
Check pins in transmitter multiplug
OK ⇒ 1.2.1
Not OK ⇒ correct fault
2
Check cables/conndections
Check connection board
Check pins in transmitter multiplug
OK ⇒ 2.1
Not OK ⇒ Correct fault
2.1
Output readings OK?
Yes ⇒ 2.1.1
No ⇒ 2.1.2.
2.1.1
Dispaly defective
Replace display
2.1.2
Transmitter defective
Replace transmitter
Note
Sensor check list
Check list for sensors are included in the respective sensor operating instructions.
9.2 Technical support
NOTICE
Repair and service must be carried out by approved Siemens Flow Instruments personnel
only.
Note
Siemens Flow Instrument defines sensors as non-repairable products.
Technical Support
If you have any technical questions about the device described in these Operating
Instructions and do not find the right answers, you can contact Technical Support:
● Via the Internet using the Support Request:
Support request (http://www.siemens.com/automation/support-request)
● Phone: +49 (0) 180 5050 222
Further information about our technical support is available in the Internet at
Technical support (http://support.automation.siemens.com/WW/view/en/16604318)