Connect wires
1. Remove cap and ferrule from cable gland and slide onto cable.
Wall mount enclosure: Remove blind plug and fit cable gland.
2. Push cable through open gland and cable path.
3. Restore ferrule and tighten cap to lightly hold cable in place.
4. Fold signal cable screen back over outer sheath and ground beneath cable clamp.
In case of shielded cables, use metal cable glands for proper connection.
5. Connect wires to terminals using screwdriver.
6. Tighten cable gland.
The numbers in the graphics below refer to table AUTOHOTSPOT.
If connected as input or output - Field mount
Active configuration Passive configuration
⑫ IO[3] (common) ⑬ IO[3]- (passive)
⑪ IO[3]+ (active) ⑫ IO[3] (common)
Functional Earth Functional Earth
Table 4-1 If connected as input or output - Wall mount
)
)
Active configuration Passive configuration
Connecting
4.2 Connecting FC430
SITRANS FC430
Compact Operating Instructions, 09/2019, A5E39940293-AB 41
To Next Page
Loading...
