Siemens Sitrans F Series - Installation instructions

Commissioning
3.4 Setting the Parameters
SITRANS FUH1010 Quick Start
24 Operating Instructions (Compact), 12/2008, CQO:QSG010 Revision A
3. To create site name use the <Up/Down> and <Right Arrow> to select a name.
4. Trigger <ENTER> sensor to save the Site name.
 

&UHDWH1DPH6LWH
!
&UHDWH1DPH6LWH
"B
① Note site name field is initially blank.
② (?) indicates cell is ready to accept data. Cursor shown at 1st character position.
③ Insert desired name (8 Characters max.)
Note
To set English or Metric units: In Meter Type Menu, scroll to Meter Facilities Menu. Press
<Right Arrow> and select desired units. Press <ENT> to select. Press <Left Arrow> and
<Up Arrow> to return to Meter Type Menu.
Note
To select alpha-numeric characters: Press <Right Arrow> to cursor and then trigger
<Up/Down Arrow> to select letters and numbers. Trigger <ENTER> when done
5. Trigger <Left Arrow> and return to [Channel Setup]. Trigger <Down Arrow> to select
[Pipe Data].
Select Pipe Class
1. Trigger <Right Arrow> to select [Pick Pipe Class].
2. Trigger <Right Arrow> again. Trigger the <Up/Down Arrows> to scroll to desired Pipe
Class.
3. Trigger <ENTER> to select Pipe Class.
4. Trigger <Right Arrow> sensor. Trigger <Up/Down Arrows> to scroll to select desired Pipe
Size.
5. Trigger <ENTER> to save Pipe Size selection.