Siemens Sitrans F Series - Final Setup

Commissioning
3.5 Transducer Installation
SITRANS FUH1010 Quick Start
Operating Instructions (Compact), 12/2008, CQO:QSG010 Revision A
33
3.5.3 Final Setup
1. After transducers are mounted scroll to [Install Complete].
2. Trigger <Right Arrow> sensor.
3. Trigger <Down Arrow> to select [Install].
4. Trigger <ENTER>.
5. Observe the Measured Vs window and verify a correct sound velocity measurement (if
known).
6. If correct, trigger the <Down Arrow>.
7. The flowmeter is now ready to report flow.

,QVWDOO&RPSOHWH"
,QVWDOO
0HDVXUHG9VPV
!
① Select "Install"
See also
Refer to I/O Connection tables for input/output wiring and flowmeter manual for data
spanning procedures.