SITRANS FUH1010 Quick Start
Operating Instructions (Compact), 12/2008, CQO:QSG010 Revision A
5
Introduction
1
This Quick Start Guide is for the Siemens SITRANS FUH1010 IP65 (NEMA 7) Single and
Dual Beam flow meters. It illustrates a typical setup using D-Series transducers in the Reflect
mode (for Direct Mode see flowmeter manual).
Note
This Quick Start Guide applies to the following FUH1010 IP65 NEMA 7 operating systems:
Version 3.03.00 and later.
1.1 Items supplied
● SITRANS F Flowmeter
● SITRANS F literature CD
● Quick Start Guide
● For additional items refer to your packing slip.
1.2 Safety Notes
Quick Start Safety Information for Hazardous Areas
DANGER
Explosion Hazard. Will Cause Death, Serious Injury or Property Damage.
Restrict use and repair to qualified personnel.
DANGER
Death or severe personal injury and/or equipment and property damage will result if proper
Hazardous (Classified) Locations installation precautions are not taken.
To Next Page
Loading...
