Commissioning
3.4 Setting the Parameters
SITRANS FUH1010 Quick Start
Operating Instructions (Compact), 12/2008, CQO:QSG010 Revision A
27
6. Trigger <Right Arrow> sensor.
7. Trigger <Down Arrow> and scroll to [D1H]. Trigger <ENTER> to select.
8. IMPORTANT: Record Number Index and Spacing Method. Trigger <Down Arrow> as
needed to locate data.
9. Transducers can now be mounted.
7UDQVGXFHU0RGHO
+37
7UDQVGXFHU6L]H
'+
,QVWDOO&RPSOHWH
1R
① Select based on type.
② Select based on size.
③ After transducer is mounted select "Install."
Transducer Identification
The transducer part number located on the front face provides a detailed identification. For
example, the
Part Number: 1011HNFS-D1HUT1-S2
means:
+ 1) 6 '+ 87 6
① Model ⑤ Size
② Hi Precision ⑥ Temperature
③ NEMA w/F-Conn ⑦ Agency Approved
④ Pipe Material
Note
Check to make sure that the transducers are a matched set with the same serial numbers
and marked with an "A" and "B" (e.g., 19256A and 19256B).
To Next Page
Loading...
