Siemens Sitrans F Series - Page 48

FUH1010 IP65 (NEMA 7) Installation Menu Chart
LEVEL A LEVEL B LEVEL C LEVEL D (see manual) LEVEL E LEVEL F
Datalogger Setup Datalogger Mode Enter From List
Datalogger Data Enter From List
LogTime Interval Enter From List
Datalog Events Enter From List
I/O Data Control Analog Out Setup Enter From List
Relay Setup Relay 1 / Relay 2
Analog Input Setup Iin1, Iin2
Diagnostic Data Path Select Enter From List
Path Enable Enter From List
Flow Data Enter From List
Application Info Enter From List
Liquid Data Enter From List
Site Setup Data Enter From List
Test Facilities Enter From List
Print Site Setup No/Yes
Date/Site Created Numeric Entry
Meter Facilities Preferred Units English/Metric
Table Setups Pipe Table Create/Edit Pipe Enter From List
Delete Pipe Enter From List
Transducer Type Enter From List
Datalogger Cntrl Output Datalogger Yes/No
Circular Memory No/Yes
Est LogTime Left View Only
Clear Datalogger Yes/No
Memory Control Data Memory Left View Only
Defragment Yes/No
Analog Output Trim Trim Io1 Operate / Trim @ 4mA
Trim Io2 Operate / Trim @ 4mA
Trim Pgen1 Operate / Trim @ 1 kHz
RTD Calibrate RTD1 Factory / User Cal
Clock Set Date (MM.DD.YY) Enter/Clear Date Format
Time (HH.MM) Enter/Clear Time Format
RS-232 Setup Baud Rate Enter From List
Parity Enter From List
Data Bits 7/8
Line Feed Yes/No
Network ID Numeric Entry
RTS Key Time Enter From List
System Info Version View Only
Reset Data/Time View Only
Op System P/N View Only
Checksum View Only
Code View Only
System Time View Only