Siemens SITRANS F US - 3.5.2 Electrical connection - transmitter to transducers (2-tracks); 3.5.3 Electrical connection - allowed cable radius; 3.6 Rotating the operating and display panel

SFIDK.PS.029.E5.02 / SW 2.01.0714
3.6 Rotating the operating and display panel
The operating and display panel can be turned in 90° steps to enable better reading in the case
of vertical installation or overhead assembly.
Procedure:
- Switch off the power supply.
- Loosen the lid lock of the electronics chamber-cover with a 3-mm Allen key.
- Unscrew the cover.
- Unlock the operating and display panel carefully at the fastening hooks alternately using a
screwdriver or similar tool, pull it out, turn it to the desired position and re-insert it.
- Screw the cover back on and mount the lid lock.
Unlocking the fastening hooks on the operating and display panel
Lid lock
3.5.3 Electrical connection - allowed cable radius
3.5.2 Electrical connection - transmitter to transducers (2-tracks)
Flow direction