Siemens SITRANS F US - Device functions and parameters; 6.1 Main menu: Display (menu 1)

SFIDK.PS.029.E5.02 / SW 2.01.07
33
Device functions and parameters 6
The following sections describe some device function parameters in the table that need further
explanations.
6.1 Main menu: Display (menu 1)
Note
Backlight setting
Off: Light turns off 3 min after last key action.
On: On for 1 hour after last key action.
Totalizer reset menu 3.4.3, 3.5.3, 3.6.5
The individual totalizers can be reset to zero with this menu. Selection takes place with the
and keys.
For all three totalizers the following possibilities exist:
- No action
- Reset + stop
- Reset + start
Reset + stop, means the totalizer will be stopped and reset.
Reset + start, means the totalizer will continue after reset of totalizer.
In the “1.3 Totalizer“ menu the total flow quantity is displayed. The display appears as a volume
or mass depending on the selection volume unit/mass unit in menus 3.4, 3.5, and 3.6.
The menu is divided as follows:
3.4 - Volume forward or mass forward (flow quantity in positive flow direction)
3.5 - Volume reverse or mass reverse (flow quantity in negative flow direction)
3.6 - Net volume or net mass (positive flow quantity minus negative flow quantity)
In menus “3.4.3”, “3.5.3”, “3.6.5”, and “Totalizer reset” the totalizer can be reset to zero - either
with stop of the totalizer or reset and on-going totalizer.
Menus 1.7 and 1.8
The arithmetically calculated output variables are displayed in the menu “Current output” and
“Frequency” irrespectively of whether the output is used.
Language selection, menu 1.1.1
If language is to be other than English – press 4 x
(yellow key) and change language into
preferred language with
key.