SFIDK.PS.029.E5.02 / SW 2.01.07
41
Unit identity, menu 5.1
Device-specific or tag-specific data can be called or entered in this menu.
Tag number, menu 5.1.1
Tag description, menu item 5.1.2
Tag message, menu item 5.1.3
Tag-specific data can be entered in these menu items. The and keys functions as cursor
control here. Numbers, letters and text characters are selected with the and keys.
If no text is stored, the end of text-character < flashes in the first segment when you enter these
menu items. By actuating the and keys, the end of text-character moves one position
to the right and one character can be selected from the character set. The following characters
are available:
Output
The selected character is entered by actuating the key and the end of text character flashes
again. Another character can be selected with the and key. The text input is ended by
actuating the
key when the end of text character flashes.
The number of characters is limited to:
- Tag number: 20 characters (8 characters in HART)
- Tag description: 20 characters (16 characters in HART)
- Tag message: 32 characters
For texts longer than 16 characters the marks < and > in the first and last segment indicate that
there are further characters to the left and/or right of the displayed text section. These are
displayed by actuating the
and keys.
Deleting texts: Select the end of text character from the character set with the and keys
and then actuate the key. All entries to the right of the end of text character are deleted.
Note
If the and keys are actuated continuously (finger continuously touching the glass panel),
the characters are automatically scrolled.
Manufacturer identity, menu 5.2
The serial number, MLFB order number and software version of the device can be read in the
individual menu items.
Nominal size, menu 5.2.5
The nominal pipe size is entered in this menu item. It is not possible to change the nominal size
without the factory code.
6.5 Main menu: Identification (menu 5)
To Next Page
Loading...
