Connecting
3.2 Si-Ware to Flowmeter Communications Setup
Si-Ware Quick Start
10 Programming Manual, 10/2011, A5E02951525-03
3.2 Si-Ware to Flowmeter Communications Setup
1. Launch the Si-Ware program (if not already running).
2. At the Si-Ware Menu bar, use the mouse to point to the [Connection] function. Click the
left mouse button once to select [Connection] and then again to select [Connect]. The
[Connect] menu will appear.
3. Click the [OK] button.
4. If the flowmeter is dual channel a [Select Channel] menu will appear. Click the desired
channel to select it.
Note
If you want to change channels in a multichannel meter you m
ust first disconnect from the
current channel, select a new channel and reconnect.
5. Click the [OK] button. [Connecting to Meter, Please Wait.../] will appear in the [Connect
Status] box as Si-Ware begins communicating with the flowmeter.
To Next Page
Loading...
