Menu Screens
4.4 Diagnostics Menu
Si-Ware Quick Start
Programming Manual, 10/2011, A5E02951525-03
25
Special Notes for the Diagnostics Screen
1. If a flowmeter channel or path goes into "Fault" the [Meter Diagnostic] screen will display
the fault code "F" in the Status field.
2. SITRANS F 1010 operating system versions 3.01.06G and later were enhanced to
provide optimal performance when interfacing with Si-Ware, therefore you can expect the
older operating systems to update the diagnostic screen at a much slower rate.
Depending on the number of channels, and whether or not ZeroMatic is enabled, the
update rate may be 20 seconds or more with older SITRANS F 1010 operating systems.
3. The format of the Data Capture file name will default to: [Site_Name Location_Name Date
Time.CSV] but can be edited and changed. This field can be easily overwritten if an
alternate file name is desired.
Figure 4-1 Data Capture Editing Field
Note
Special Char
acters
If you perform a Data Capture function you can not create and name a Data Capture file
until you remove all the MS Windows special characters. The special characters it does
not allow to be used in file names are \ / : * ? " < > |
If you have any special characters in the site name they have to be edited in the [File
Name] edit box in the [Data Capture Function] screen section.
4. To accommodate gas industry standards, the displayed Flow Rate units and Sound
Velocity units may be different from the flowmeter units. For example: The flowmeter may
indicate KcuFt/hr, but Si-Ware will display this as MSCFH.
Note
The Mete
r Di
agnostic screen will appear with the "Y" axis scaling menu on the left side of
the screen when the PC monitor resolution is less than 1024 x 768 pixels; however, all
functions are identical to the large screen example shown above.
To Next Page
Loading...
