Menu Screens
4.6 Utilities Menu
Si-Ware Quick Start
Programming Manual, 10/2011, A5E02951525-03
37
Figure 4-4 Gas Composition and Mole Fraction % Screen
4. To mix input gases, select gases and input percent of each gas as needed.
5. If the total is not 100% select the [Normalize] button to force the total of all selected gases
to equal 100%.
6. Use the [Clear] button to clear all data and input new gas data as needed.
7. Click [OK] to verify data and close the screen.
Gas/Process Calcs. Tab
1. Select desired inputs from the [Gas Sensor Selection and Sizing Tool] screen.
2. Click the [Calculate] button.
3. If parameter inputs are successful the screen will display all the gas/process calculations
for the flowmeter.
Figure 4-5 Gas/Process Calcs. Tab
To Next Page
Loading...
