SITRANS FCS200
Operating Instructions, 02/2011, A5E02508199-01
23
Service and maintenance
7
7.1 Maintenance
The device is maintenance-free, however, a periodic inspection according to pertinent
directives and regulations must be carried out.
An inspection can include check of:
● Ambient conditions
● Seal integrity of the process connections, cable entries, and cover screws
● Reliability of power supply, lightning protection, and grounds
7.2 Recalibration
Siemens A/S Flow Instruments offers to recalibrate the sensor. The following calibrations are
offered as standard:
● Standard matched pair calibration
Note
For recalibration the memory unit must always be returned with the sensor
7.3 Unit repair
CAUTION
Repair and service must be carried out by Siemens authorized personnel only.
Note
Siemens defines flow sensors as non-repairable products.
To Next Page
Loading...
