EDM eco
Display lighting Operating instructions
26 © Siemens VDO Trading GmbH TU00-1404-0311020
Display lighting
Standby mode
A few minutes after the engine has been switched off, the light on the EDM eco consumption
display unit goes out.
Switching on the display lighting
The display lighting can be switched from standby mode at any time, e. g., if you want to call up
journey data when the vehicle is not in motion.
Setting the brightness of the display
The brightness of the display lighting can be set in 2 stages.
■
Press any key to switch the display lighting from standby mode.
■
Press the key briefly to make the display lighting brighter or darker.
To Next Page
Loading...
