WA_DEV_GL6100_PTS_001 Rev 002 May 24, 2010 70
GL61x0 Product Technical
Specification and User Guide
Reliability Standards: Compliance and
Recommendations
Environmental testing - part 2-38: Test Z/AD: composite
temperature/humidity cyclic test.
Basic environmental testing procedures - part 2: Test Z/AM combined
cold/low air pressure tests.
Road vehicles - environmental conditions and testing for electrical and
electronic equipment - part 1: general.
Road vehicles - environmental conditions and testing for electrical and
electronic equipment - part 2: electrical loads.
Road vehicles - environmental conditions and testing for electrical and
electronic equipment - part 3: mechanical loads.
Road vehicles - environmental conditions and testing for electrical and
electronic equipment - part 4: climatic loads.
Degrees of protection provided by enclosures (IP code).
Basic environmental testing procedures - part 2: Test Q: sealing.
Environmental testing - part 2-18: Tests - R and guidance: water.
Environmental testing - part 2: tests - test XB: abrasion of markings and
letterings caused by rubbing of fingers and hands.
Environmental testing - part 2: tests - test l: dust and sand.
Basic environmental testing procedures, part 2: test KA: salt mist.
Environmental testing - part 2: Test KE: flowing mixed gas corrosion test.
Environmental testing - part 2: Test KB: salt mist, cyclic (sodium chloride
solution).
13.3. Environmental Specifications
The GL61x0 is compliant with the operating classes listed in the table below. The ideal temperature
range of the environment for each operating class is also specified.
Table 53: Operating Class Temperature Range
To Next Page