Signal SDS Series - Introduction to SDS Series Controllers; SDS Series Overview and Capabilities

To Next Page

To Previous Page

SDS Series

Introduction

Thank you for purchasing a SIGNAL SDS Series irrigation controller.

The SIGNAL SDS Series is an Australian designed and manufactured irriga-

tion control system, designed for ease-of-use programming, while allowing

for the complex requirements of both landscape and agricultural applica-

tions.

The modular design of SDS Series controllers makes servicing possible for

the owner/operator - with easily accessible replacement plug-in electronic

modules.

The SDS-50 controller has a capacity to operate 48 solenoid valves from a

central location via two-wire or multi-wire installation. The SDS-100 in-

creases this number to 96. In the event of two-wire, 12 programmable

DataNodes™ facilitate the connection of sensors along the cable. An addi-

tional 6 controller direct inputs on the controller terminal. Up to two 24 di-

rect relay output modules can be connected at any location on the two-wire

cable for conventional 24VAC solenoid operation.

With SDS Series controllers, there’s no need for separate valve decoders.

Simply connect the cable direct to the SIGNAL DataCoil™.

Communication options include 3G/4G modem, WiFi and ethernet. These

enable remote programming and monitoring via SignalCloud Central Con-

trol Software (Web-based) or the SignalGo App for iPhone/iPad and An-

droid.

Made in Australia