Silvercrest SSM 1000 A2 - Interrupt the Cooking Process; Setting Cooking Program and Starting

61
GB
10.3 Setting cooking
program and starting
NOTE: the cancel button Keep Warm/
Cancel37 allows you to cancel the set-
tings or a running program at any time.
1. Press the desired program button. The
LEDs above the program button and
above the Start button Start44 will
flash. The display29 shows the cook-
ing time set as Normal51 and the pre-
set cooking time will flash.
As long as the LEDs and the display are
flashing, the settings for the time and pres-
sure level can be changed.
NOTE: the preset values and the adjustable
ranges can be found in the table in chapter
“Overview of functions” on page 53.
2. If desired, first change the pressure level:
Press the pressure button Pressure
Level
 40 to switch between High  54
and
Low  56 .
3. The change the cooking time within the
adjustable range:
- Repeatedly press the program button
to switch between the default settings
Less, Normal, More51.
- You can use the buttons +33/–46 if
necessary to set the desired time man-
ually.
- By keeping the buttons +33/–46
pressed, you can cycle through the
values faster.
4. Briefly press the Start button Start44
to start the cooking program.
- The LEDs above the selected program
button and above the Start button
Start44 will be lit continuously.
- The display29 will show ON and a
running progress bar55, indicating
that the device is heating up and
building up pressure.
- This may take some time depending
on filling volume and cooking pro-
gram.
5. When the temperature and pressure
have been reached, the cooking pro-
gram starts automatically.
- The display29 counts down the
cooking time.
- In order to maintain the temperature,
the device automatically switches
back and forth between heating up
(progress bar55 running) and heat-
ing switched off (progress bar55 sta-
tionary).
6. The end of the cooking process is sig-
nalled by beeps. The device automati-
cally switches to the warm program.
The LED of the Cancel button Keep
Warm/Cancel 37 is lit. The dis-
play29 counts the warm time upwards
from 00:00. The pressure is slowly re-
leased.
10.4 Interrupt the cooking
process
• To cancel a running program, press the
Cancel button Keep Warm/Can-
cel37.
The device is then in standby mode. The
display29 will show OFF.
57
This symbol indicates that
the device is heating up
and building up pressure.
53
This symbol indicates that
the set pressure has been
reached.
P
__367792_2101_Schnellkochtopf_CY.book Seite 61 Mittwoch, 9. Juni 2021 10:18 10