Silvercrest SSM 1000 A2 - 10.5 End Cooking; Warm (Keep Warm;Cancel)

62
GB
10.5 End cooking
1. End the cooking program or the warm
program by pressing the Cancel button
Keep Warm/Cancel37.
The display29 shows OFF. The device
is in standby mode.
2. Pull the mains plug11 out of the wall
socket.
3. Select a suitable method for reducing
the pressure in the pot and safely open-
ing the lid5 (see “Opening lid safely
(while hot)” on page 57).
4. Remove the hot pot7 using potholders
or oven gloves.
5. Allow the device to cool down before
you clean it.
10.6 Warm (Keep Warm/
Cancel)
When a cooking program has ended, the
device automatically switches to the warm
program Keep Warm/Cancel37.
You can also start the warm program manu-
ally in order to keep hot food warm in the
Multi-Pot.
NOTES:
• Keeping food warm for very long peri-
ods changes the flavour and appear-
ance, vitamins are destroyed, and the
food can go bad.
• Because the warm program works with-
out pressure, you can open and close
the lid5 while the program is running.
You should however be aware of any
residual pressure that may be present af-
ter another cooking program.
• After the yoghurt program ( Yogurt  43 ),
the device does not automatically switch
to the warm program.
1. Place the hot food into the pot7.
2. Wipe down the outside of the pot7 if
necessary. It must be clean and dry.
3. Place the pot7 into the base unit13.
4. Place the lid5 and lock it, such that the
arrow marking6 points to the
marking 9. The locking mecha-
nism will click audibly.
5. Open the pressure valve1 by pressing
down on the pressure valve button
2 until it clicks into place.
6. Use the mains power cable11 to con-
nect the port14 on the base unit13 to
a properly installed earthed wall socket
that corresponds to the technical data.
7. As soon as the device is connected to
the power supply, the display29 will
show OFF. The device is in standby
mode.
8. Click the Cancel button Keep Warm/
Cancel37 to start the warm program.
The LED of the Cancel button Keep
Warm/Cancel37 is lit. The dis-
play29 counts the warm time upwards
from 00:00.
After 12 hours, the warm program ends
automatically.
9. Click the Cancel button again to end
the warm program Keep Warm/
Cancel37.
The LED of the Cancel button Keep
Warm/Cancel37 goes out. The dis-
play29 will show OFF. The device is in
standby mode.
10. Pull the mains plug11 out of the wall
socket.
11. Open the lid5 and place it in the drip
dry position (see “Placing lid in drip-dry
position” on page 55).
12. Remove the hot pot7 using potholders
or oven gloves.
13. Allow the device to cool down before
you clean it.
__367792_2101_Schnellkochtopf_CY.book Seite 62 Mittwoch, 9. Juni 2021 10:18 10