Silver Peak Hardware Reference Guide Warning Statements
40 PN 200972-001 Rev B
Warning Statements
Class 1 Laser Products
Maintenance Port Precautions
The serial console is only used for periodic maintenance and not to be used under normal operation.
General Safety
CAUTION Please note the following:
1 The server will not be used in a home, school or other public area where the general population
would have access to it.
2 The manufacturer specifies that the thumbscrew normally should be tightened with a screwdriver.
Use of a thumbscrew is not considered to compromise the basic principles of safety associated with
the standard.
WARNING To prevent potential for personal injury, property damage or death, please
observe the following instructions:
• Do not use damaged equipment, including exposed, frayed or damaged power cords. Use only
the approved power cable that is rated for the equipment. The voltage and current rating of the
cable should be greater than the ratings marked on the equipment.
• Plug the power cables into properly grounded electrical outlets
• Do not use adapter plugs or remove the grounding prong from a cable.
If you must use an extension cable, use a 3-wire cable with properly grounded plugs.
• Observe extension cable and power strip ratings to ensure that the total ampere rating of all
equipment plugged into the extension cable or power strip does not exceed 80 percent of the
ampere ratings limit for the extension cable or power strip.
• When connecting or disconnecting power to hot-swappable power supplies, observe the
following precautions:
• Install the power supply before connecting the power cable to it.
• Unplug the power cable before removing a power supply.
NX-8700 EC-S (only with optional fiber module)
NX-9600 EC-M
NX-9700 EC-L
NX-10700 EC-L-NM
NX-11700 EC-XL
EC-XL-NM
To Next Page
Loading...