CM5_UM_ 9752090319_GB_V0_9 44 / 67
6000 Menu for changing advanced generator settings.
6100 Submenu with general settings for the generator.
6200 Submenu for limiting the HV output.
6300 Submenu for the Remote HV on/off settings.
6400 Submenu for the Advanced Output Control mode settings (this menu is only
available if 1400 and 6780 are active).
6410 Set minimum (start) Setpoint for the voltage that is output when the
analogue control input reaches the trigger level (see 6440).
6411 Set the minimum (start) Setpoint for the output voltage.
6420 Set maximum Setpoint for the voltage that is output when the
maximum level is reached (see 6430).
6421 Set the maximum Setpoint output voltage.
6430 Set maximum level of the analogue control input.
6431 Set the maximum level of the analogue control input.
6440 Set threshold level of the analogue control input.
6441 Set the threshold level of the analogue control input.
6500 Submenu for the display settings.
6510 Set delay time for displaying the most recently measured high voltage
value after this has been reduced.
6511 Set the display readout delay time.
6520 Set delay time of the limit LED indicating how long the limit LED must
remain illuminated after a limit situation is no longer present.
6521 Set the limit LED readout delay.
6530 Set display mode for the display.
6531 Voltages and currents are shown in kV and mA.
6532 Voltages and currents are displayed as a % (percentage) of
the maximum.
6540 Set intensity of the display backlight.
6541 Set the intensity of the display backlight.
6550 Set contrast value for the display text.
6551 Set the contrast value for the display text.
6600 Submenu for the settings for the analogue I/O inputs and outputs.
6700 Submenu with information about the generator.
6800 Menu for restoring the factory settings for the generator.
To Next Page
Loading...