CM5_UM_ 9752090319_GB_V0_9 56 / 67
Appendix III Standard settings (CM5 with Anybus module)
The CM5 with Anybus module has the following factory settings:
Operating mode: Fieldbus
Control mode: VC (=Voltage Control)
Voltage setpoint: 0.0 kV
Current limit: 2.5 mA (or 5.0 mA)
Lock mode: Unlocked
User password: Unchanged
Bus address: 126
User voltage limit: 60.0 kV (or 30.0 kV)
User current limit: 2.5 mA (or 5.0 mA)
Local source: Continuous
Remote source: Continuous
Fieldbus source: Bus
Remote limit control: Local controlled
Advanced output control: Continuous
Advanced output control:
Voltage setpoint start: 5.0 kV
Voltage setpoint max.: 15.0 kV
High level: 80%
Trigger level: 10%
Readout stretched: 0.7 sec.
Limited LED stretched: 0.7 sec.
Display readout: kV & mA
Backlight: 85%
Contrast: 50%
Remote I/O mode output U: 0–5 V DC
Remote I/O mode output I: 0–5 V DC
Remote I/O mode setpoint U: 0–5 V DC
Remote I/O mode setpoint I: 0–5 V DC
Remote I/O mode advanced output control: 0–5 V DC
Remote I/O mode leak detect/bar contamination: 0–5 V DC
Pin9 output mode: Not used
To Next Page
Loading...