CM5_UM_ 9752090319_GB_V0_9 46 / 67
6000 Menu for changing advanced generator settings.
6100 Submenu with general settings for the generator.
6200 Submenu for limiting the HV output.
6300 Submenu for the Remote HV on/off settings.
6400 Submenu for the Advanced Output Control mode settings.
6500 Submenu for the display settings.
6600 Submenu for the settings for the analogue I/O inputs and outputs.
6610 Set mode of the analogue output for the remote Actual Voltage.
6611 Set analogue control range to 0–5 V DC.
6612 Set analogue control range to 0–10 V DC.
6613 Set analogue control range to 0–20 mA DC.
6614 Set analogue control range to 4–20 mA DC.
6620 Set mode of the analogue output for the remote Actual Current.
6621…6624 See descriptions for 6611 to 6614.
6630 Set mode of the analogue input for the remote Voltage Setpoint (VC
mode)/Voltage Limit (CC mode).
6631…6634 See descriptions for 6611 to 6614.
6640 Set mode of the analogue input for the remote Current Limit (VC
mode)/Current Setpoint (CC mode).
6641…6644 See descriptions for 6611 to 6614.
6650 Set mode of the analogue input for the remote Advanced Output
Control.
6651…6654 See descriptions for 6611 to 6614.
6660 Set mode of the analogue input for the remote Bar Contamination.
6661…6664 See descriptions for 6611 to 6614.
6670 Set mode of use for the sub-D pin 9.
6671 Sub-D pin 9 is used for sending Arc Detect messages.
6672 Sub-D pin 9 is used for sending Limit Alarm messages.
6673 Sub-D pin 9 is not used.
6700 Submenu with information about the generator.
6800 Menu for restoring the factory settings for the generator.
To Next Page
Loading...