CM5_UM_ 9752090319_GB_V0_9 48 / 67
6000 Menu for changing advanced generator settings.
6100 Submenu with general settings for the generator.
6200 Submenu for limiting the HV output.
6300 Submenu for the Remote HV on/off settings.
6400 Submenu for the Advanced Output Control mode settings.
6500 Submenu for the display settings.
6600 Submenu for the settings for the analogue I/O inputs and outputs.
6700 Submenu with information about the generator.
6710 Information about the type of generator.
6720 Information about the firmware version of the software.
6730 Network information about the connected Anybus module.
6740 Version information about the connected Anybus module.
6750 Serial number of the connected Anybus module.
6760 Option for indicating whether the Anybus module is activated.
6770 Option for indicating whether the Advanced Current Control module is
activated.
6780 Option for indicating whether the Advanced Output Control module is
activated.
6790 Option for indicating whether the Bar Contamination module is
activated.
6800 Menu for restoring the factory settings for the generator.
6810 Default option to prevent unintentional resetting of the factory settings.
6820 By activating this option the factory settings are reset.
Note:
During the resetting of the factory settings, the user password is NOT reset. In order to reset
the user password, the procedure in section 6.22 must be followed.
To Next Page
Loading...