Simex MultiCon CMC-99/141 User Manual

User Manual For - CONTROLLER/DATA RECORDER MultiCon CMC-99/141
•
Function
parameter set as
Mean X[i]
,
•
Source X
parameter select
logical channels 1÷8
, which was defined as a
reading of the thermocouples temperature,
•
X error handling
parameter set as
errors forwarded to result
,
– for
Displaying
block parameters:
•
Format
parameter set as
numeric
,
•
Precision
parameter set as
0
,
• in
Graph low
parameters write
-200°C
,
• in
Graph high
parameter write
1370°C
,
The next step is to define Groups set up logical channels to view them in two windows
on the screen. To do this:
– enter the
Group
menu to enable the Group 1 if it is off,
– in the
Name
write
Measure Temp. 1
,
– for
Channels
block parameters:
•
Slot 1
parameter set as
logical channel 9
called the
Mean value
,
•
Slot 2
parameter set as
logical channel 1
called the
Temperature 1
,
•
Slot 3
parameter set as
logical channel 2
called the
Temperature 2
,
•
Slot 4
parameter set as
logical channel 3
called the
Temperature 3
,
•
Slot 5
parameter set as
logical channel 4
called the
Temperature 4
,
•
Slot 6
parameter set as
logical channel 5
called the
Temperature 5
,
– all the other parameters in this
Group
should be on default settings,
– using the arrows in the top navigation bar, select any
Group
(except 1) such as 2,
– in the
Name
parameter write
Measure Temp. 2
,
– for
Channels
block parameters:
•
Slot 1
parameter set as
logical channel 6
called the
Temperature 6
,
•
Slot 2
parameter set as
logical channel 7
called the
Temperature 7
,
•
Slot 3
parameter set as
logical channel 8
called the
Temperature 8
,
•
Slot 4÷6
parameter set as
disabled
,
– all the other parameters in this
Group
should be on default settings,
The last step is to define the
Initial view
displayed on the LCD screen when the device
starts. The initial view has to display a defined group of logical channels in the values mode.
To do this:
– enter the
General settings
menu,
– for
Initial view
block parameters,
•
Display mode
parameter set as
values
,
•
Displayed group
parameter set as
Group 1: Measure Temp. 1
,
Finally, you must exit the menu by pressing the button
Save changes
. The result of the
changes will be visible after calling the first measurement. Use
[↓ GROUP]
or
[GROUP ↑]
button in the navigation bar to switch between display groups.
139

Simex MultiCon CMC-99/141 Specifications

General

Brand	Simex
Model	MultiCon CMC-99/141
Category	Controller
Language	English