Simoniz S1750 - User Manual

Other manuals for Simoniz S1750

Operator's Manual28 pages

Questions and Answers

C
coletimothySep 12, 2025
Why does my Simoniz S1750 motor buzzes but fails to run?
- C
  Cody JamesSep 12, 2025
  If your Simoniz Pressure Washer motor buzzes but doesn't run, it could be due to several reasons. First, the supply voltage might be below the minimum requirement; verify that only the pressure washer is running on the circuit. Another possibility is residual pressure in the system; turn the unit “OFF”, squeeze the trigger on the spray wand to release the pressure, and then turn the unit “ON.” Voltage loss due to an extension cord could also be the cause; unplug any extension cords and plug the unit directly into the outlet.
A
andersonellenSep 13, 2025
What causes Simoniz S1750 Pressure Washer spray wand, extension, or nozzle to leak?
- A
  asummersSep 13, 2025
  If your Simoniz Pressure Washer's spray wand, extension, or nozzle is leaking, it might be because the spray nozzle isn't properly attached. Ensure that you insert the spray nozzle into the trigger gun, carefully press it in against the spring tension, and twist it into the locked position. If the issue persists, it could be due to a broken o-ring or plastic insert.
V
Victoria DanielsSep 15, 2025
Why water leaks from pump of Simoniz S1750?
- M
  Margaret RobinsonSep 15, 2025
  If water is leaking from the pump of your Simoniz Pressure Washer (more than 10 drops per minute), it could be due to loose fittings. Ensure that all fittings are tight. If the leak continues, the water seals may be damaged or worn.
M
mannstephanieSep 17, 2025
Why oil is dripping from Simoniz Pressure Washer?
- S
  Samantha LopezSep 18, 2025
  If oil is dripping from your Simoniz Pressure Washer, it is likely that the oil seals are damaged or worn.