Chapter 5. Manually Programming NACs, Relays, and DACT
5-11
Note: Event codes for SIA and BFSK are non-editable.
Saving Changes
When DACT programming is complete, press the EXIT/
CLEAR key until the following prompt is shown.
[Cont] Dscrd Save
Use the right arrow key to move the cursor to one of the fol-
lowing options and press <ENTER>.
• Cont - continues the edit session.
• Dscrd - exits the edit session without saving your
changes (keeps the job that was loaded before you
started editing).
• Save - saves your edit changes
Note: Both discard and save restart the panel.
Manual Test
Report
E EE 3A RX0
Off-normal at
test
F F8 33 YX0
Table 5-5 Event Categories and Codes (Continued)
Event 3/1 BFSK 4/2 SIA
Technical Manuals Online! - http://www.tech-man.com
To Next Page
Loading...
