Edit System Options .......................................................................................................................... 3-2
Restore Default System Options........................................................................................................ 3-3
Saving the Configuration.................................................................................................................... 3-3
Default Programming Assignments ................................................................................................... 3-3
Chapter 4. Manually Programming IDNet Points..................................................... 4-1
Accessing IDNet Programming Menus .............................................................................................. 4-2
Adding an IDNet Device..................................................................................................................... 4-2
Editing IDNet Device Attributes.......................................................................................................... 4-2
Deleting an IDNet Point ..................................................................................................................... 4-8
Chapter 5. Manually Programming NACs, Relays, and DACT................................ 5-1
Accessing Menus............................................................................................................................... 5-2
Programming NACs ........................................................................................................................... 5-2
Programming AUX Relays ................................................................................................................. 5-4
Programming DACT........................................................................................................................... 5-6
Accessing DACT Menu...................................................................................................................... 5-6
Programming DACT Options ............................................................................................................. 5-7
Programming Contact ID (CID) Points ............................................................................................... 5-9
Programming Event Codes.............................................................................................................. 5-10
Saving Changes............................................................................................................................... 5-11
Chapter 6. Manually Programming Annunciators ................................................... 6-1
Adding an Annunciator....................................................................................................................... 6-2
Accessing Annunciator Menus........................................................................................................... 6-2
Programming LEDs Located on Zone Annunciator and Remote LED/Switch Modules..................... 6-3
Programming Panel and LCD LEDs .................................................................................................. 6-6
Common LED Applications ................................................................................................................ 6-7
Programming LCD Annunciator Attributes ......................................................................................... 6-7
Saving Changes to the Job................................................................................................................ 6-9
Technical Manuals Online! - http://www.tech-man.com
To Next Page
Loading...
Need help?
General
