Page 26
Document No: 4020-M010 1st February, 1997 Issue 2.0
Key 6 is isolate (ISOL) Key
It is used to isolate or de-isolate zones/circuits through the
keyboard when in the function lists controlled by keys 1, 3, 7, and
8, eg:
To very quickly de-isolate the 5 zones that are in the isolated
condition, press ISO LIST (3) which gives access into the list, then
press the Isol (6) key which de-isolates, press it again which de-
isolates the next one. It will automatically scroll through and de-
isolate at the same time as displaying the next item.
Key 7 is input zone list key
This function lists the zones present in the system. As each system
can have between 8 and 48 zones. To list the zones press Key 7.
This takes you to the beginning of the list. Press plus or minus
keys to scroll through the list to look at the devices or to relate
zones to floor levels etc. The display shows the zone number, a
description of the location, the type of device and its number, and
its condition ie. normal/isolated. To get out of the list press the
escape (ESC) key. Table 1.1 lists the various device types:
Key 8 is output list key
The output key has the same function as the input key except it is
for the output circuits. To access the list of output controls, press
OUTPUT(8) and scroll through using the plus and minus keys and
look at the output control devices. To exit the list press the escape
(ESC) key.
Key 9 is On/Off
The On/Off (9) key has no function on this panel.
6
ISOL
7
INPUT
8
OUTPUT
9
ON/OFF
To Next Page
Loading...
