Simplex Contact Closure DACT - Exiting the Programmer

3-19
To exit the Programming Function, use the following procedure. Note: If you
need to get to the C> prompt, press ESC.
1. At the C> prompt, type EXIT. Then press [↵] or [↓].
a. If you made changes to the program during the current session, the
screen displays:
.
OR…
b. If you made no program changes during the current session, the screen
displays:
2. If you made changes to the program, your answer to “Question 1a“
determines what happens next.
a. If you press [N], the screen displays:
OR…
b. If you press [Y], the screen displays:
Exiting the Programmer
Exiting With or
Without Changes
SAVE CHANGES Y/N?
NO CHANGES MADE...
EXITING
CHANGES NOT SAVED...
EXITING
CHANGES SAVED...
EXITING
firealarmresources.com