Simrad CR50 MKII User Manual

CR40/42/50 MKII DGPS ChartRadar Index
170
Electrical connections - cont’d,
-optional connections 131
-power supply 130
ETA&AVNdisplay 69
Factory settings 117
Global Positioning System 5
Glossary of terms 153
GOTO function 29
HDOP limit 46
Heading from external sensor 36
INFO windows 22
-bearing and dist. from A to B 23
-cursor to center 23
-chart setup 32
-cursor active but not placed
on object or data 23
-cursor inactive 22
-cursor placed on route/line leg 25
-cursor placed on route/linepoint26
-cursor placed on target 28
-cursor placed on trackpoint 27
-cursor placed on waypoint 24
-edit user data 24
-GOTO function 29
-PLOT function 30
-plot new data 30
-select NAV mode 29
-shiptocenter 22
Installation,
-antenna, GPS & DGPS 128
-connection cables 139
-connector’s pin numbers and
wire colors 145
-CR40/42 121
-CR50 123
Installation - continued,
-DS40/42/50 126
-grounding wire 147
-notes 119
-place of display unit 125
-radar adjustment after instal. 148
-RS4050 125
-scanner 133
Interface setup, alarm/log 113
Interface setup, NMEA 109
Introduction 5
Key functions 10
Key symbols in the manual 6
Language 16,107
Light and contrast 15
Line drawing 30
-display 56
-edit line 25,26,57
-names 32
Lines stored in the memory 56
Local time 36
Log 35
-reset log 37
Log speed calibration 107
Log speed sensor 107
Loran C 115
Maintenance 148
Measurement units 107
Memory 118
Menu bar 12
Menu layout 13
MOB function back of front cover
-navigation 73
-position display 44
Naming of routes, points, etc. 15

Simrad CR50 MKII Specifications

General

Brand	Simrad
Model	CR50 MKII
Category	Marine Equipment
Language	English