CR40/42/50 MKII NAV menus & navigation examples Chapter 6
75
6.5.2 Waypoint navigation
There are two ways of activating Waypoint navigation:
From the chart or from the menu.
From the chart:
CHART
Shortcut to chart 1 display
Press the cursor key to activate the cursor, then move the chart cursor
to your destination waypoint (or select it from the WPlist - see below)
GOTO
Select NAV mode, and…
2
Select Waypoint from WPlist (if chart cursor is placed on a WP, this
WP will be highlighted in the WPlist.
This will activate the pop-up window ‘Navigate to WP’ - now follow
the procedures from the ) a few lines down.
From the menu:
MENU
Call up the menu bar, and…
4,2
select “WP” in Navigation menu
) This will activate the pop-up window “Navigate to WP” from where
you can choose which waypoint you wish to sail to:
Use the cursor to scroll up/down in the waypoint list, or place cursor
on the WP number, and…
+/-
Scroll up/down with +/- keys, or…
0-9
Key in the number of the waypoint you wish to sail to
ENT
Start navigation
A course line will now be drawn from ship’s position to destination
waypoint.
It is possible to mix and match the data you require to have on the
To Next Page
Loading...
Need help?
General
