9
Speed
-
It controls the printing and travel speeds.
-
If you print large object with a high “Fill Density”, please reduce the “Travel Speed”.
Retraction / Cooling
-
Sets control values for the retraction of filament and nozzle cooling fan.
Multi Nozzle
-
It is enabled only for the 2X or 2X DP303.
-
It is a window to set profile when using multiple nozzles.
-
For outputting a large printout with the multi-nozzle, set the lowering bed value to be larger (0.8 mm
recommended) than the default value (0.2 mm).
Wipe Tower
-
It is enabled only for the 2X and 2X DP303. This feature is recommended for use when printing
on one layer with two cartridges.
1. While using other nozzle, wipe off any leaking filament residue from the waiting nozzle to maintain a
smooth output surface.
2. When the nozzle is replaced, the filament is first output to the Wipe tower to compensate for
the filaments leaked from the nozzle.
To Next Page
Loading...
